Depending on requirements, ARP offers chip cutting units for a great variety of materials and chip sizes. The size reduction of the chips is imperative for transportation in pipe systems. ARP chip cutting unit systems with a chip chamber screen ensure a uniform pumpable chip quality.

In conjunction with drying, breaking-up considerably increases market value of the chips.

Double shaft cutting units are usually used for breaking steel chips, and single shaft cutting units are often used for materials such as aluminium, brass or copper.

The size of the material to be cut up is determined by the screen plate. Small screen perforations are used for stiff and needle-shaped chips (0.5-1.5 mm), and large screen perforations are used for leaf-shaped and broad chips.

The cutting unit is protected against overloads and over-sized pieces by a specific control system.

AZ 250 centrifugal chip separator

Fields of application:

For drying steel chips, aluminium chips, non-ferrous metals

Performance data:
Throughput rate
for steel:
ca. 250 kg/h.
Driving power:
3 kW
Weight:
270 kg
Structural dimensions
W x L x H:
x x mm
Residual moisture:
3 - 5 %

Subject to technical changes

AZ 500 centrifugal chip separator

Fields of application:

For drying steel chips, aluminium chips, non-ferrous metals

Performance data:
Throughput rate
for steel:
approx. 800-2500 kg/h
Driving power:
7,5 kW
Diameter of drum:
600 mm
Drum speed:
1200 U/min.
Residual moisture:
3 - 5 %

Subject to technical changes